Acroprint ES1000 - Manual (Page 13)

ES1000 User’s Manual 7
Atomic Synchronization
The ES1000 receives the NIST WWVB Signal which will automatically set the time and date.
When the ES1000 is searching for the Atomic Signal, the following characters will alternate on
the display:
When the ES1000 has found the Atomic Signal and set the time and date, the Atomic Symbol will
remain on:
For more information about the WWVB Radio Signal (Atomic Signal), visit NIST’s
website at:
www.boulder.nist.gov .
If the Atomic Symbol is not on and steady, try repositioning the ES1000 for better signal
reception. If no symbol is on, you will need to set the time and date manually.
Set your time zone (refer to “Time Zone” on page 10 ) for the Atomic Synchronization to
perform properly.
The Atomic Synchronization will automatically adjust for the Daylight Saving Time
(DST).