Panasonic EY7549 User Manual

Page 17

Advertising
background image

- 17 -

• The ambient temperature range is

between 0°C (32°F) and 40°C (104°F).

If the battery pack is used when the

battery temperature is below 0°C

(32°F), the tool may fail to function

properly.

• When charging a cool battery pack

(below 0°C (32°F)) in a warm place,

leave the battery pack at the place

and wait for more than one hour to

warm up the battery to the level of

the ambient temperature.

• Cool down the charger when charging

more than two battery packs consecu-

tively.

• Do not insert your fingers into contact

hole, when holding charger or any

other occasions.

To prevent the risk of fire or damage to

the battery charger.

• Do not use power source from an

engine generator.

• Do not cover vent holes on the char-

ger and the battery pack.

• Unplug the charger when not in use.

NOTE:

Your battery pack is not fully charg-

ed at the time of purchase. Be sure

to charge the battery before use.

Battery charger

1. Plug the charger into the AC outlet.
2. Insert the battery pack firmly into the

charger.
1. Line up the alignment marks and

place the battery onto the dock on

the charger.

2. Slide forward in the direction of the

arrow.

Alignment marks

3. During charging, the charging lamp will

be illuminated.

When charging is completed, an inter-

nal electronic switch will automatically

be triggered to prevent overcharging.

• Charging will not start if the battery

pack is warm (for example, immedi-

ately after heavy-duty operation).

The orange standby lamp will be

flashing until the battery cools down.

Charging will then begin automati-

cally.

4. The charge lamp (green) will flash

slow ly once when the battery is ap-

proxi mately 80% charged.

5. When charging is completed, the

charging lamp in green color will turn

off.

6. If the temperature of the battery pack

is 0°C or less, charging takes longer to

fully charge the battery pack than the

standard charging time.

Even when the battery is fully charged,

it will have approximately 50% of the

power of a fully charged battery at nor-

mal operating temperature.

7. Consult an authorized dealer if the

charging lamp (green) does not turn

off.

8. If a fully charged battery pack is in-

serted into the charger again, the

charging lamp lights up. After several

minutes, the charging lamp in green

color will turn off.

Battery pack
release button

9. Remove the battery pack while the

battery pack release button is held

up.

Advertising