Panasonic DMWFL360E - Manual (Page 14)

14
VQT1B11
Checking the Flash’s
Remaining Battery
Charge
≥ Install the batteries and then turn
on the unit and check the battery
remaining power.
1 Press the [POWER] button.
≥ Charging now starts.
2 Check that the [TEST/
CHARGE] button lights.
≥ After the batteries have been fully
charged, the [TEST/CHARGE]
button lights.
≥ If it takes as long for the [TEST/
CHARGE] button to light as the
period indicated in the table below,
it means that the batteries are
nearly worn out. Replace them
with fresh batteries as soon as
possible.
≥ If the [TEST/CHARGE] button and
[AUTO CHECK] lamp both flash at
the same time, it means that the
batteries are almost completely
worn out and should be replaced
with fresh batteries as soon as
possible.
3 Press the [POWER] button
to turn off the unit’s power.
≥ When the [TEST/CHARGE] button
is pressed, the unit may fire.
≥ Turn off the power in the following
situations:
≥ When mounting the unit onto, or
disengaging it from, the digital
camera
≥ When you do not want the unit
to fire
≥ When you are not going to use
the unit
POWER
TEST/CHARGE
Alkaline batteries More
than 30 s
Rechargeable nickel
metal hydride
batteries
More
than 10 s
VQT1B11.book 14 ページ ２００６年８月３１日 木曜日 午後４時３６分