Panasonic KXPRWA10FX - Manual (Page 5)

5
• Do NOT use Alkaline/Manganese/Ni-Cd batteries.
• Confirm correct polarities (S, T).
Charge for about 7 hours.
• Confirm “Charging” is displayed (B).
• When the batteries are fully charged, “Fully charged” is displayed.
Note:
• The handset display may show “Please wait for 1 minute.” when the handset is
placed on the charger if it is not registered to the base unit.
• If the batteries are fully charged, but the operating time seems to be shorter, clean the
battery ends (S, T) and the charge contacts with a dry cloth and charge again.
Display language
1
{ Menu} (right soft key) (11)
2
{ r} : Select your desired language. s {OK} s {T}
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {T} for few seconds
to turn the handset on.
1 Handset:
Lift the handset and press {T}.
2 Base unit (page 3: 3):
Press and hold {x} for about 5 seconds.
• If all registered handsets start ringing, press {x} again to stop, then repeat this step.
3 Handset:
Place the handset on the base unit or charger.
• Continue the operation even when the handset display shows “Please wait for 1
minute.”.
4 With the handset still on the base unit or charger, wait until a confirmation tone sounds
and w is displayed.
Note:
• If an error tone sounds, or if _ is displayed, register the handset according to the base
unit’s operating instructions.
PRSA_WA10FX(fx).book Page 5 Thursday, July 25, 2013 1:30 PM