Panasonic SCHTE180EG - Manual (Page 10)

10
R
Q
T9939
10
Note:
The default setting is underlined. Changed settings will be
kept until it is changed again, unless otherwise indicated.
Audio format
You can view the current audio format.
Press and hold [SOUND] for a minimum of 4 seconds.
Setup Menu
1
Press [SETUP] repeatedly to select the setup item.
2
Press [R, T] repeatedly to select the desired
setting and then press [OK].
Note:
The default setting is underlined. Changed settings will be
kept until it is changed again, unless otherwise indicated.
AGC Auto gain control prevents sudden loud
sound by reducing the sound level
automatically when the input is too
high.
ON
OFF
LOW VOL
MODE Enhance the dialog in low volume
condition.
ON
OFF
Select “OFF” to cancel this effect if the
dialog does not sound natural in low
volume condition.
DOLBY
DIGITAL Dolby Digital is the audio source.
DTS DTS is the audio source.
PCM MULTI Linear pulse-code modulation is the
audio source.
PCM 2 channel pulse-code modulation is
the audio source.
ANALOG Analog is the audio source.
SBC Sub-band Coding is the audio source.
(Bluetooth
® mode only)
DIMMER Dims the display panel after
5 seconds of inactivity.
ON
OFF
AUTO POWER
DOWN The system automatically switches off
if there is no audio input and when you
do not use it for 20 minutes.
ON
OFF
VOL
LIMITATION Sets the volume limit to 50 when you
switch on the system although the
volume is set to above 50 before it is
switched off.
ON
OFF
BLUETOOTH
STANDBY This function allows you to connect a
paired Bluetooth
® device when this
system is in standby mode.
ON
OFF
The system will switch on
automatically when you connect a
paired Bluetooth
® device.
LINK MODE Change the Bluetooth ® connection
link mode to suit the connection type.
Make sure to disconnect the current
connected device (“BLUETOOTH
READY” is shown).
MODE 1: Emphasis on connectivity.
MODE 2:
Emphasis on sound quality.
VIERA LINK Switch on the VIERA Link function.
ON
OFF
Select “OFF” when your HDAVI
Control device does not work
correctly with this system. ARC will be
disabled. Connect an optical digital
audio cable.
Switch off all connected devices and
then switch them on again after
changing the setting.
RQT9939-Z.book Page 10 Monday, February 10, 2014 6:17 PM
printing
Confidential
Until: 10 Mar 2014