Panasonic KXTGA910FX - Manual (Page 8)

8
Note:
• If you select a language you cannot read, press {ih}, press J, select
m , press L, push the joystick down 2 times, press L, push the joystick
down 2 times, press L, select the desired language, then press L.
Press {ih}.
Registering the handset to KX-TG9120 base unit
Ensure that the handset is switched on. If it is not on, press and hold {ih}
for few seconds to turn the handset on.
1 Lift the handset and press {ih} to put the handset in standby mode.
2 Press and hold {x} on the base unit for about 3 seconds, until the
registration tone sounds.
3 Place the handset on the base unit. The registration tone continues to
sound. With the handset still on the base unit, wait until a confirmation
tone sounds and w stops flashing.
Note:
• If an error tone sounds, or if w is still flashing, register the handset
manually. (See manual registration in the KX-TG9120 operating
instructions.)
• If all registered handsets start ringing in step 2, press {x} to stop. Start
again from step 1.
• Charge the batteries for about 7 hours before initial use.
TGA910FX(fx).book Page 8 Wednesday, August 30, 2006 4:49 PM