Apple Macintosh LC 550 - Manual (Page 33)

28 12.
Slide the logic boar
d back in
.
Push on the edge of the logic board until it is finally in place.
13.
If ther
e is a connector on the car
d that you just
installed
(for example, if you ar
e installing an Apple IIe
Car
d), r
emove the access cover on the back panel you
removed earlier
.
Pinch together the plastic tabs on the access cover to remove it and pop it out. With the access cover off
, you can use the
port on the card you just installed.
14.
R
eplace the back panel of the computer
.
Slip the back cover over the prongs at the bottom edge of the back of the computer
. If your back panel was held on by
screws, replace them.
s
Wa
rning:
Never tur
n on your computer unless all of its
inter
nal and exter
nal parts are in place. Operating the
computer when it is open or missing parts can be dangerous, and can damage your computer
.
s