Apple Xserve G5 User Manual
Xserve g5 user’s guide
Advertising
Table of contents
Document Outline
- User’s Guide
- Contents
- Preface 7 Introducing Xserve G5
- Chapter 1 9 Xserve G5 Overview
- Chapter 2 21 Preparing to Install Your Server
- Chapter 3 25 Installing Your Server in a Rack
- 26 Getting Ready to Install
- 28 Preparing the Server for Installation
- 32 Installing the Server in a Four-Post Rack or Cabinet
- 46 Installing the Server in a Short Four-Post Rack
- 51 Installing the Server in a Two-Post (Telco) Rack
- 55 Disconnecting Cables From the Server’s Back Panel
- 56 Preparing the Server for Software Setup
- Chapter 4 57 Using Your Server
- 57 Starting Up the Server
- 58 Monitoring Status Lights and Other Indicators on the Server
- 58 Working With Advanced Network Services
- 59 Controlling Access to a Connected Keyboard and Mouse
- 60 Working With an Uninterruptible Power Supply (UPS)
- 60 Changing the System Language
- 60 Shutting Down the System Remotely
- 61 If the Server Has a Problem
- 63 Entering Firmware Boot Commands From the System’s Front Panel
- Chapter 5 65 Updating or Installing Software on Xserve G5 Systems
- Chapter 6 69 Installing or Replacing ServerComponents
- Appendix A 85 Specifications
- 85 Processor and Memory Specifications
- 85 Dimensions and Operating Environment
- 85 Optical Drive Specifications
- 85 Ethernet Specifications
- 86 FireWire Specifications
- 86 USB Specifications
- 86 Serial Port Specifications
- 87 Power Supply
- 87 Power Requirements for Devices You Can Connect
- 87 System Clock and Battery
- Appendix B 89 Safety, Maintenance, and Ergonomics
- Introducing Xserve G5
- Xserve G5 Overview
- Preparing to Install Your Server
- Installing Your Server in a Rack
- Getting Ready to Install
- Preparing the Server for Installation
- Installing the Server in a Four-Post Rack or Cabinet
- Installing the Server in a Short Four-Post Rack
- Installing the Server in a Two-Post (Telco) Rack
- Disconnecting Cables From the Server’s Back Panel
- Preparing the Server for Software Setup
- Using Your Server
- Starting Up the Server
- Monitoring Status Lights and Other Indicators on the Server
- Working With Advanced Network Services
- Controlling Access to a Connected Keyboard and Mouse
- Working With an Uninterruptible Power Supply (UPS)
- Changing the System Language
- Shutting Down the System Remotely
- If the Server Has a Problem
- Entering Firmware Boot Commands From the System’s Front Panel
- Updating or Installing Software on Xserve G5 Systems
- Installing or Replacing ServerComponents
- Specifications
- Safety, Maintenance, and Ergonomics
- Communications Regulation Information