Panasonic SCAKX14EG - Manual (Page 10)

10
RQ
T 961
5
10
“NOT MP3/ERROR”
• An unsupported MP3 format. The system will skip that
track and play the next one.
“VBR–”
• The system cannot show the remaining play time for
variable bit rate (VBR) tracks.
“NORMAL”
• The “INPUT LEVEL” of AUX source automatically
changes from “HIGH” to “NORMAL” when the system
detects distorted music sounds.
“NODEVICE”
• The USB device is not connected. Examine the
connection.
Memory reset (initialisation)
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC mains lead.
2
While you press and hold [1] on the main unit,
connect the AC mains lead again.
“– – – – – – – –” is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
Remote control code
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
Press [RADIO, EXT-IN] (main unit: [RADIO/EXT-IN]) to
select “AUX”.
To set the code to “REMOTE 2”
1
Press and hold [RADIO/EXT-IN] on the main unit
and [2] on the remote control until “REMOTE 2”
is shown.
2
Press and hold [OK] and [2] for a minimum of
4 seconds.
To set the code to “REMOTE 1”
1
Press and hold [RADIO/EXT-IN] on the main unit
and [1] on the remote control until “REMOTE 1”
is shown.
2
Press and hold [OK] and [1] for a minimum of
4 seconds.
Maintenance
To clean this system, wipe with a soft, dry cloth
• Never use alcohol, paint thinner or benzine to clean this
system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
AKX14EG.en.book Page 10 Thursday, January 5, 2012 12:50 PM