Agilent Technologies HSSI WanProbe J3916A - Manual (Page 31)

Introduction
Status LEDs
11
Rear Panel Telemetry LEDs
The telemetry LEDs are located on the back of the probe. (See Figure 1-4.)
10Base-T/100Base-TX Telemetry Interface Status LEDs
On the back of the probe, there are LEDs associated specifically with each
interface and a Power LED. The 10Base-T/100Base-TX telemetry interface has
LEDs for Activity, Link and Collision.
Link. This green LED is turned on when the probe is attached to a 10Base-T/
100Base-TX network.
Collision. This yellow LED is turned on when the probe detects collisions on the
network.
Figure 1-3: Front Panel LEDs