ACR Electronics ZE-NES14 - Manual (Page 44)

44
INSTALLATION AND UNINSTALLATION
TRIM RING INSTALLATION
■
Attach the trim ring around the front panel with two indentions on one side facing
upwards.
UNINSTALL
Disassemble trim ring
1. Push the trim ring upward and pull out the upper part.
2. Push the trim ring downward and pull out the lower part.
DISASSEMBLE THE UNIT
1. Unscrew the 4 pieces M2 x 2 screws.
2. Use a screw driver to bend straight the bended mounting tab and tip out the unit from
the mounting bracket.
3. Pull out the unit from the mounting bracket with both hands.
Unscrew 4
attached screws
Remove the rubber sheath