Panasonic ESRT81 - Manual (Page 11)

11
English
Removing the built-in rechargeable batteries
Remove the built‑in rechargeable batteries before disposing of the
shaver. Please make sure that the batteries are disposed of at an
officially designated location if there is one. Do not dismantle or
replace the batteries so that you can use the shaver again. This
could cause fire or an electric shock. Replace them at an
authorized service center.
Disconnect the power cord from the shaver when removing the
batteries.
Perform steps 1 to 5 and lift the batteries, and then remove
them.







For environmental protection and recycling of materials
This shaver contains Nickel‑Metal Hydride batteries.
Please make sure that the batteries are disposed of at an
officially assigned location, if there is one in your country.
Please read “Information for Users on Collection and Disposal of
Old Equipment and used Batteries” on page 17.
•
•
. Gently wipe off any beard trimmings
attached to the inside of the cleaning
tray with a cloth or tissue paper
dampened with water.
Clean the corners and uneven parts
of the cleaning tray with a cotton
swab dampened with water. •
Warning
Do not wash or apply water to the adaptor or self-cleaning
recharger. Failure to observe this may cause electric shock
or result in short circuits.
Do not pull hard on the rubber blade protector at the bottom of
the cleaning tray. The rubber may come off if you pull hard on it.
It is only necessary to pull it up slightly. •
When the water does not drain from the cleaning
tray
Beard trimmings may clog the drain at the
bottom of the cleaning tray.
In this case, you cannot clean or dry the
shaver.
Push the beard trimmings down through the
drain with a tooth pick etc.
