Panasonic NE-17521 - Manual (Page 16)

- 16 -
PAD INSTRUCTION DIGITAL DISPLAY WINDOW
5 Within 3 seconds after pressing Prog pad at step 4, press Start pad.
“PROG” will start to blink. 
The display changes to 1st, 2nd, and 3rd each time the pad is pressed
and the settings change.
*The length of beep tone at the end of heating cycle
1st : 3 beeps
2nd : short beeps for 60 seconds
3rd :“Beep” sounds for 5 seconds, and then 3 beeps sound 30 seconds
later and again 60 seconds later.
(Buzzer reminder functions to prevent food forgotten in the oven)
6 Press Prog pad.
“PROG” will stop blinking, and the set length of beep tone at the end of

heating cycle will appear for 3 seconds.
Then “0” will appear.
To proceed to Step 7, press Start pad before “0” is displayed after Step 6.
7 Within 3 seconds after pressing Prog pad at step 6, press Start pad.
“PROG” will start to blink.

The display changes to “ ”, “ ”, and “ ” each time the pad is
pressed and the settings change (Under the “bE” in “bEEP”).
*The pitch of beep tone at the end of heating cycle
: Low, : Normal, : High
8 Press Prog pad.
“PROG” will stop blinking, and the set pitch of beep tone at the end of

heating cycle will appear for 3 seconds.
Then “0” will appear.
To proceed to Step 9, press Start pad before “0” is displayed after Step 8.
9 Within 3 seconds after pressing Prog pad at step 8, press Start pad.
“PROG” will start to blink.

The display changes to “ ”, “ ”, and “ ” each time the pad is
pressed and the settings change (Under the “EP” in “bEEP”).
*The pitch of filter cleaning alarm
: Low, : Normal, : High
10 Press Prog pad.
“PROG” will stop blinking, and the set pitch of filter cleaning alarm will

appear for 3 seconds.
Then “0” will appear.
Note: When the filter cleaning alarm counter setting is “0”, you cannot perform steps 9 and 10.
How to Operate
0'#2RFH