Panasonic NE-17521 - Manual (Page 21)

- 21 -
IMPORTANT
Disconnect the power cord from the wall socket 1.
before attempting installation.
For stacking installation, you must use the
2.
PANASONIC Joint Plate (sold separately).
The combination of the units for stacking is limited to
3.
only the following PANASONIC models:
Models No.
NE-12521, NE-12523, NE-17521,
NE-17523, NE-17723, NE-21521,
NE-21523
The 4. maximum stacking height is the total heights of
two units.
PREPARATION
Be sure the oven cavity is empty. Be sure surfaces
where ovens meet is clean and sanitized.
INSTALLATION
Stack the units and remove five screws (a) as shown in Fig.1. 1.
Loosen the screw (b). 2.
Projection on Joint Plate must face away from the oven. Place Joint Plate on the screw (b). 3.
Attach and tighten five screws (a) and the screw (b). See Fig.2. 4.
Ensure the top oven is at a safe and workable height. 5.
(b)
Joint Plate
Projection
(a)
Fig. 1 Fig. 2
Joint Plate
Projection
Sanitary Counter Top Seal
When microwave oven units are stacked on a
counter top, their base must be sealed in
accordance with NSF Standards as per the
following instructions.
Microwave oven should be located on a level counter 1.
top surface. Complete the electrical connections.
Thoroughly clean the microwave oven bottom
2.
perimeter and the counter top area around the
microwave oven perimeter.
Lay generous bead of silicone seal around the entire
3.
perimeter of the base of each microwave oven unit.
Smooth the silicone seal into the crevice with finger
4.
or tool to provide a cove seal.
Note: Remove the Air Filter from the front of the oven
before applying silicone.
DO NOT FORGET to re-install the Air Filter
after applying silicone.
Silicone Sealant
Counter Top
Installation Instructions for Stacking
0'#2RFH