Panasonic MC-CL933 - Manual (Page 32)

- 32 -
Vacuum cleaner 1. Unplugged at wall outlet. 1. Plug in firmly, move switch to
won’t start. FLOOR or CARPET position.
2. Tripped circuit breaker/blown 2. Reset circuit breaker or replace
fuse at household panel fuse.
Poor job of dirt 1. Full or clogged dust cup. 1. Empty and clean dust cup.
pick-up. 2. Clogged airflow passages. 2. Clear airflow passages.
3. Dirty filters. 3. Change filters.
4. Suction control is open. 4. Check both suction controls.
5. Hole in hose. 5. Replace hose.
6. Dust cup installed incorrectly. 6. See DUST CUP
7. Dust cup lid and dust cup 7. See PRE-FILTER
missembled
Vacuum cleaner starts 1. Tripped thermal protector in 1. Reset thermal protector.
but shuts off. canister.
Vacuum cleaner picks 1. Suction too strong. 1. Open suction control.
up moveable rugs
-or- Power Nozzle
pushes too hard.
Cord won’t rewind. 1. Dirty power cord. 1. Clean the power cord.
2. Cord jammed. 2. Pull out cord and rewind.
Vacuum cleaner 1. Wrong vacuuming pattern. 1. See VACUUMING TIPS.
leaves marks on
carpet.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
BEFORE REQUESTING SERVICE
WARNING
Electric Shock or Personal Injury Hazard.
Disconnect the electrical supply before performing maintenance to the vacuum cleaner.
Failure to do so could result in electric shock or personal injury from vacuum cleaner
suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems. Any
service needed, other than those described in these Operating Instructions, should be
performed by an authorized service representative.