Panasonic SC-BTT465 - Manual (Page 33)

33
Ad
va
n
ced
o
p
erati
o
n
s
VQT5F60
Speaker installation option
Consult a qualified building contractor when
attaching the speakers to a wall. Improper
attachment may result in damage to the wall and
speakers and personal injury.
You can attach all of the speakers (except
subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to
be attached should be capable of supporting
10 kg (22 lbs) per screw.
1
Drive a screw (not supplied) into the wall.
A At least 30 mm
(1 3 /
16
q)
B ‰ 4.0 mm ( 5 /
32
q)
C ‰ 7.0 mm to
‰ 9.4 mm
(
9 /
32
q to 3 /
8
q)
D Wall or pillar
E 5.5 mm to 7.5 mm
( 7 /
32
q to 5 /
16
q)
2
Fit the speaker securely onto the screw(s)
with the hole(s).
Use the measurements indicated below.
≥ Leave at least 20 mm (
25 /
32
q) of space above the
speaker and 10 mm ( 13 /
32
q) on each side to
allow enough space for fitting the speaker.
CENTER
A 14 mm
( 9 /
16
q)
B 65 mm
(2 9 /
16
q)
C 175 mm
(6 29 /
32
q)
[BTT466] [BTT465] FRONT
Attach to a wall without the base and the stand.
≥ Before using the speaker cable, remove it from
the stand by pulling it out.
D 45 mm
(1 25 /
32
q)
E 53 mm
(2 3 /
32
q)
F 266 mm
(10 1 /
2
q)
≥ Reattaching the speaker cable to the stand
[BTT466] [BTT465] SURROUND
[BTT405] FRONT, SURROUND
G 42 mm (1 21 /
32
q)
H 45 mm (1 25 /
32
q)
Attaching to a wall
e.g., Surround speaker
DO NOT DO
≥ In this position, the
speaker will likely fall if
moved to the left or right.
≥ Move the speaker so
that the screw is in this
position.
Screwing positions on the
wall











Straighten the cable and run through the stand.
Pull out the cable through the hole.
160 mm (6 5 /
16
q)


SC-BTT466&465&405P-VQT5F60_mst.book 33 ページ ２０１４年３月２４日 月曜日 午前１１時３２分