Panasonic MC-UG725 - Manual (Page 42)

- 42 -
Replacing Belt
Agitator Holder
Support de l’agitateur
Soporte de l’agitador
Lift Agitator Up
Soulever l’agitateur
Unidad del agitador
Belt Cover
Couvercle de
la courroie
Cubierta de
la banda
Install
New Belt
Poser la
nouvelle
courroie
Instalación
de la correa
Motor Shaft
Arbre
d’entraînement
du moteur
Eje del motor
Groove
Ouverture
Ranura
End Cap
Bouchon
Tapa de extremo
➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ Remove lower plate.
➢ Lift rear belt cover and remove
agitator holder.
➢ Remove agitator by carefully lifting
out.
➢ Remove worn or broken belt.
➢ Clean agitator.
➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and
agitator pulley.
➢ Reinstall agitator back into nozzle
housing grooves.
➢ Close rear belt cover and reinstall
agitator.
➢ After reinstalling the agitator, turn it
by hand to make sure that belt is
not twisted or pinched and that all
rotating parts turn freely.
➢ Reinstall lower plate. (See
Removing and Installing Lower
Plate, page 40).