Panasonic TY-EW3D2SU - Manual (Page 9)

ENGLISH - 9
Charging
„ „ Charging the 3D Eyewear
1. Turn off the television power, and set the 3D Eyewear power switch to
“OFF”.
2. Connect as shown in the diagram, and turn on the television power.
• The indicator lamp lights red, and charging starts.
• When the indicator lamp turns off, charging is complete.
(Approximately 2 hours required)
3. Turn off the television power, and remove the charging cable.
Mini USB connector
USB connector
NOTE
• For the USB terminal, see the television operating instructions.
• Be sure to turn the television power on when charging. The battery will not be
charged when the television power is off.
Storage and Cleaning
Clean using a soft, dry cloth.
Wiping the 3D Eyewear with a soft cloth that is covered in dust or dirt may scratch the
eyewear. Shake off any dust from the cloth before use.
Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the
paint to peel off.
Do not dunk the 3D Eyewear in liquid such as water when cleaning.
Avoid storing the 3D Eyewear in hot or highly humid locations.
NOTE
• As the liquid crystal shutters (lens) are fragile and easily broken, be very careful
when cleaning them.