Panasonic KX-HCM110A - Manual (Page 64)

Operating Instructions
64
2.7.2 Connecting the Camera to a Router Not Supporting
UPnP™ (IPv4 Only)
To allow access from the Internet with a router not supporting UPnP TM , follow the
procedures below.
1.
Select [Static] on the Network (IPv4) page.
2. Enable port forwarding on the router.
Using the IP address and port number note written on step 1-(3), enable port
forwarding on the router. See the router manual for how to enable port
forwarding.
3. Register with the DynamicDNS service.
Port Forwarding feature *1 (IPv4 Only)
The port forwarding feature is required to allow access from the Internet with a
router not supporting UPnP
TM . It exchanges a local IP address to a global one.
Each camera must be assigned a unique port number.
(1) Access the camera (see page 13).
(2) Click [Setup] tab at the top of the page.
(3) Select [Static] on the Network page.
•
The Static IP Address Configuration page is displayed. Make a
note of the IP address and port number, since they are required to
enable port forwarding on the router.
(4) Click [Save] without changing the settings.
(5) Click [Restart].
*1 "Port forwarding" may be called "Address translation", "Static IP Masquerade", "Virtual server"
or "Port mapping" in other products.
Global IP address
of the router
vvv.xxx.yyy.zzz:80
vvv.xxx.yyy.zzz:81
vvv.xxx.yyy.zzz:80 192.168.0.253:80
vvv.xxx.yyy.zzz:81 192.168.0.252:81 Port No.
Port Forwarding feature
Local IP address
The IP addresses shown above may differ from those offered on your home network.
Note
192.168.0.1
192.168.0.252
Port No. 81
192.168.0.253
Port No. 80
Router Modem
CATV
xDSL
Optical cable
Internet