Atmos Energy INTERCOMBI HE32 User Manual

Atmos, Intercombi, Installation & servicing instructions for he32

Advertising

Atmos

InterCombi

Installation & Servicing Instructions for HE32

(GC 47-249-01)

Atmos Heating Systems

West March

Daventry

Northants, NN11 4SA

Tel: 01327 871990

Fax: 01327 871905

e-mail:

[email protected]

internet: www.atmos.uk.com

Issue 22.01.10 (Main revision)

Advertising

Table of contents

Document Outline

Issue 22.01.10 (Main revision)
This manual
Abbreviations and names used
Icons
Service and technical support
Environment
Intended use
Atmos Warranty – Short version
Exceptions
SAFETY REGULATIONS
- General
- CH system
- Gas system
- Electrical system
- Domestic water system
- Flue discharge and air supply
DESCRIPTION OF THE APPLIANCE
- General
- Operation
- Operating conditions
  - - Off
- PC interface
- Test programmes
  - Test programmes
  - Frost protection
MAIN COMPONENTS
- Accessories
INSTALLATION
- Overall dimensions
- Unpacking the appliance
- Additional dimensions
- Boiler location
- Mounting and General Information
- Mount the appliance
- Fit the pipework cover (optional item)
- Condensate disposal
CONNECTIONS
- Connect the CH system
- Hot water system
  - Appliance with pre-heating by solar system
- Connecting the gas supply
- Electrical connection
- General Flue Requirements
- Flue discharge and air supply
- Roof outlet prefabricated chimney
  - Maximum pipe length
    - Mounting of prefabricated chimney
- Atmos MS System
  - Maximum pipe length
    - Mounting of air supply - horizontal
    - Mounting flue terminal - vertical
- Atmos Communal Flue System (CFS)
  - Atmos CFSEO – FA System
    - Maximum pipe length
    - Common flue discharge
  - Atmos CFS System
    - Maximum pipe length
COMMISSIONING
- Fill and de-aerate the appliance and the system
- Commissioning of the appliance
  - Remarks
- System Shutdown
  - Frost protection
    - Note!
SETTING AND ADJUSTMENT
- Directly via operating panel
  - Appliance on/off
- Settings through the service code
- Parameters
- Setting maximum CH power
- Setting pump position
- Weather-dependent control
- Conversion to other gas type
  - Conversion of the gas setting ring
- Gas-air control
- Setting gas-air control
  - Setting by measuring the CO2 content of the flue gases
    - Setting the gas valve by pressure measurement
- Carbon monoxide : carbon dioxide ratio
FAULTS
- Burner does not ignite
- Burner ignites with much noise
- Burner resonates
- No heating (CH)
- Reduced output
- CH does not reach the correct temperature
- No hot water (HW)
- Hot water does not reach the correct temperature
SERVICING THE BOILER AND COMPONENT REPLACEMENT
- SERVICING THE BOILER
- COMPONENT REPLACEMENT
TECHNICAL SPECIFICATIONS
- Electrical diagram
CE DECLARATION

Popular Brands

Popular manuals