Actiontec electronic HPE400T - Manual (Page 20)

17
Setting Up Static
IP Address
To communicate with a MegaPlug 4-Port Hub from a computer on the network,
the user may have to switch the
IP address settings from DHCP -enabled to static IP ,
so that the computer and the Hub are on the same subnet.
To set up static IP on a computer, select the operating system and follow the
instructions.
☞
Note: The following procedures are based on the Hub’s factory
default IP address. If the Hub’s IP address has been changed,
enter the new IP address when instructed to enter an IP address.
Windows 98 SE
1. From the desktop, click on the Start button in the lower left corner.
2. From the menu that appears, select Settings.
5