Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 98)

Chapter 2 - Installation
BreezeACCESS VL System Manual
66
2.6.4 BS-AU Network Interface Module
Figure 2-22 shows the front panel of the BS-AU Access Unit Network Interface
module.
Figure 2-22: BS-AU Front Panel
The BS-AU provides the following interfaces:
„ 10/100 BaseT: A 10/100BaseT Ethernet connector for connecting the BS-AU
to the network. A straight Ethernet cable should be used to connect the
module to a hub, router or switch.
„ RADIO: A 10/100BaseT Ethernet connector for connecting the BS-AU to an
AU-ODU outdoor unit.
CAUTION
Do not connect the data equipment to the RADIO port. The RADIO port supplies DC power to the
ODU, and this may harm other equipment connected to it.
The recessed RESET switch on the front panel is for resetting the outdoor unit.