Panasonic 616 - Manual (Page 70)

70
Step 1
Press the [SUB MENU] button.
→ The submenu window will be displayed.
Step 2
Move the cursor onto the [Camera control] button of
the submenu, and then press the [SET] button.
→ The menu list will be displayed. Move the cursor
onto "Camera menu" on the displayed menu list,
and then press the [SET] button.
→ The camera menu will be displayed and the cam-
era setup menu will be displayed on the monitor.
Note:
• The status bar will be hidden while the camera
menu panel is being displayed.
Operate the setup menu of the camera
To control the camera connected to the recorder, it is necessary in advance to configure the settings of the
camera function. The settings of the camera function can be configured on the setup menu of the camera.
It is possible to call the setup menu of the camera from the submenu. The contents of the setup menu and the
operation procedures vary depending on the model of the camera. Refer to the operating instructions of the
camera for further information.
The following are descriptions of how to display the setup menu of the camera and of how to perform the basic
operation.
Step 3
Operate the setup menu of the camera using the
camera menu panel.
To operate the setup menu of the camera, use the fol-
lowing buttons.
Move the cursor Arrows button ( C D A B)
Change parameters Arrows button ( A B)
Apply the set value or
move to the lower level
menu [SET] button
Move to the higher level
menu [SETUP/ESC] button
Display the special
menu Move the cursor onto
"SPECIAL" on the setup
menu of the camera, and
then press the camera
selection button [2].
Reset the camera Move the cursor onto
"CAMERA RESET" on the
setup menu of the camera,
and then press the camera
selection button [3].
Step 4
To close the setup menu of the camera, press the
camera selection button [4].
Note:
• When the camera has the refresh function
(REFRESH), it is possible to execute the refresh
function by selecting the [2] button on the camera
menu panel.
• The camera menu panel may sometimes remain
displayed after the setup menu of the camera is
closed such as when resetting the camera, etc. In
this case, select the [4] button on the camera
menu panel.
• Only users whose user level is allowed to control
cameras or to configure the settings can configure
the settings of the camera.