Panasonic 616 - Manual (Page 47)

47
Step 3
Specify the search conditions (filters).
Date and time range: Designate the recording start
time and date and the end time and date of
recorded images to be searched for by rotating
the jog dial (inside).
Move the cursor onto the entry field, and then
press the [SET] button. The software keyboard (for
time and date entry) will be displayed and the time
and date can be entered using it. Refer to pages
21 and 25 for how to use the software keyboard
(for time and date entry).
REC event: Select an event type of recorded images
to be searched for from the following. The check-
box respective to the selected event type will be
checked. (When selecting "All", all the checkbox-
es will be checked.)
• Event
Manual recording, schedule recording, emer-
gency recording, video loss, terminal alarm,
command alarm, video motion detection
(VMD), camera site alarm
• i-VMD
Motion detection, object appearance/disap-
pearance, terminal alarm, residence detection,
direction detection, interruption detection
Camera: Select the desired camera channel used for
recording to be searched.
The checkbox respective to the selected camera
channel will be checked. To select all camera
channels, select "All".
[Clear Filtering] button: Cancels the specified
search conditions (filters).
Values for the start time and the end time of "Date
and time range" will become the same, and all the
checkboxes for "REC event" and "Camera" will be
checked.
Step 4
Move the cursor onto [OK] after specifying the search
conditions (filters), and then press the [SET] button on
the front panel.
→ Recording events matched the search conditions
will be displayed in the recording event list.
Step 5
Select the desired recording event to play. To select a
recording event, rotate the jog dial (inside).
Note:
• When the shuttle ring (outside) is rotated, the pre-
vious/next page of the list will be displayed.
Step 6
Move the cursor onto the [ B] (play) button, and then
press the [SET] button on the front panel.
→ Playback of recorded images of the selected
recording event will start.
Step 7
To stop the playback, press the [STOP] button on the
front panel.
→ Playback will stop. Playback on monitor 2 will be
switched to live image display.
Note:
• When starting playback from the displayed
recording event list after filtering, only recorded
images of the listed recording events are subject
to play. It is possible to make all recorded images
available to play by stopping the playback and
starting playback again.