Panasonic HD Writer 2.0E User Manual
Page 95
95
When a problem occurs
Settings/Convenient information
Copy
When the following problem occurs
Confirm the following
SD card is not displayed on the Copy
window.
z
If you insert the SD card into the video camera and then connect it to the PC, it will not
be displayed if the video camera has not been set for connection with the PC. (For
details, refer to the operating instructions for the video camera.)
z
An SD card is not displayed when DVD connection is selected as the setting when
connecting the HDC-SX5. Change the setting to SD connection.
z
An SDHC memory card (4 GB to 8 GB) will not be displayed unless using a
reader/writer that supports SDHC.
The video camera is connected but not
displayed on the screen or recording
fails.
z
Some video cameras are not supported by Windows
®
2000.
z
If a video camera is connected that does not support the recording of images from a
PC, the video camera can be used only for reading data from media, but not for
recording data. (It is not displayed as the recording destination.)
An error message is displayed when
selecting the destination.
z
Close any other software using the drive.
z
An error message may be displayed when a disc is replaced. Select the drive again.
z
Other recording software may be interfering with the operation. In this case, uninstall the
other recording software.
The DVD disc is displayed as not being
supported.
z
DVD+R discs and DVD+RW discs cannot be used.
z
Before copying the DVD-RW disc, DVD-R disc, and DVD-R DL (dual layer on single
side) disc in the AVCHD standard recorded by video camera, the discs must be finalized
with the video camera used for the recording.
Cannot record even though the
DVD-RAM disc is new.
z
Commercially available DVD-RAM discs are initialized (formatted) in UDF 2.0 format so
it is necessary to format them on this software in UDF 2.5 format.
ENG-HDW20.book 95 ページ ２００７年６月２９日 金曜日 午後１時４０分