Balboa Water Group Adjustable VSR Retrofit Kit - Manual (Page 2)

Picture 4
Picture 5a Picture 5b
7. Slide the ring all the way down ensuring that there is no gap between the ring and the shoulder.
8. Clean up any excess glue from the jet body.
9. Hold the ring with some pressure for few seconds until PVC glue has bonded the ring with the jet body as
illustrated in Pictures 5a & 5b.
10. Insert the new handle and nozzle assembly into the jet body.
11. Rotate the new handle assembly counter clockwise ensuring that the tab on the bottom of the handle is lined
up with the slot on the face of the jet body. You may need to apply some force to engage locking mechanism.
See Pictures 6a & 6b below.
12. Gently rotate the handle from right to left and then from left to right to ensure that it opens and closes freely.
13. Turn on all electrical power to the SPA including water pump and heater.
14. Fill the SPA with water.
15. Gently rotate the handle from right to left and then from left to right to ensure that it works properly.
Line up the tab
with the slot as
illustrated
Shoulder
Picture 6a Picture 6b Tab on the
bottom of
the handle
Slot on the
jet body
42011 A June 4, 2010 Page 2 of 2