EXONIC EXD 6805 - Manual (Page 32)

-31-
1). Place the Car Kit and mobile hand-
set in 3 meters apart.
3). Set your BT phone to
“discover” the Car Kit .
Following your phone’s instruction
guide for details, active your mobile
handset’s BT, the
handset will search for accessible
BT devices.
4). Your phone will find this Car Kit .
Select this Car Kit from the list.
5). Enter passkey “8888”, then press
“OK” to pair the Car Kit and the hand-
set .
1. “Pair” To Your BT Phone
Prior to using the Car Kit for the fist time,
you must pair it with a BT-enabled
mobile handset.
The following steps describes pairing
the instruction for a typical BT-
enabled mobile handset.
Touch Screen Operation
BT OPERATION
2. Using The BT Car Kit.
Once connecting is complete, you
may access the following function.
Some of the below mentioned funct-
ions only accessible for handset
supported with hands-free profile.
Touch the screen of “ ” section ,
the dial numbers will display on the
monitor . then you can touch the
number section on screen , and
then touch the “ ” section to call .
MAKE A CALL
CALL DIAL OUT
13800138000
To return to main menu
Function
zone
Function
zone
Please note : “ ” and “ ” serves as
the “ ” and “ ” button on your
mobile handset .
Note: When you dial the wrong number,
you can touch the screen of “ ” to
delete the wrong number . (You can also
press the “ ” button on the remote
control to do so .)
2). Put the Car Kit in pairing mode.
a.Press the POWER button to turn
ON, the BT ICON will flash on TFT .
b. Touch the screen of “ ” section
or press longer the
“PAIR/ ” on
the remote control until the word
“ BT ” icon flashing , it’s now ready
for pairing.
6). Select the “CONNECT” from the list
on the phone, if you connect succes-
sfully , the BT ICON remains solid on
the screen , then you can operate
the function of BT about the
unite .
IMPORTANT:
1). If the pairing can not be completed
within approximately 2 minutes ,
whiles the pairing mode is activated,
and you will need to reattempt pairing
(See steps 2-5 above) .
2). After pairing is completed, if the BT
ICON is stilling flash on the TFT ,
please follow the steps to reattempt
pairing through your handset until the
BT ICON remains solid on the screen.