Audiovox CCS-100 - Manual (Page 6)

Double fold to shorten
Crimp with pliers
Bend to clear Throttle Cable
Throttle Arm
Throttle Cable
Bead Chain
(#20)
3 Bead Connector
(#27)
UNDER HOOD INSTALLATION
Connecting the Cruise Control Cable to the Throttle
NOTE: Prior to attaching servo cable to throttle, locate an accessible area to mount the cruise control servo,
but do not mount it. Leave the servo in this area (unmounted) and route cable to throttle attachment area.
CAUTION: Attach the cruise control cable so that it parallels the existing throttle cable as nearly as possible.
Choose a mounting method from the figures below:
Attachment area for
securing cable
Bead Chain
Coupling Sleeve (#23)
Bead Chain Coupling (#24)
3 BEAD CONNECTOR FIG. 6 FIG. 7 FORD LINKAGE ADAPTOR
Rubber Ring
WIRE LOOP FOR PULLEY
Carburetor
Existing Snap-On Throttle Arm On Vehicle
FIG. 2 SNAP-ON THROTTLE ARM MOUNT FIG. 3 CLAMP-ON THROTTLE ARM MOUNT
Determine a suitable point on the throttle linkage to mount the cable connector. The mounting point chosen should have between
1-1/2" to 2" total linkage travel. It must operate smoothly by hand. There should be at least 5 beads between the throttle connector and
servo cable end. The cable must pull in a straight line from throttle linkage. Some vehicles that do not have enough total linkage travel
have to be connected at the accelerator pedal.
The bead chain and servo cable end must be
inserted into the bead chain connector. Then the
bead chain coupling sleeve must slide over
bead chain connector to insure that the end will
not hang in the connector.
FIG. 1
Cable
Bead Chain Eyelet
Connector (#25)
Pull off Throttle Arm and Insert Bead Chain Connector between it
and Carburetor Arm. Be sure additional thickness of adaptor does
not bind linkage.
20°
Bead Chain Eyelet
Connector (#25)
Cable Must Be within 20° of
same angle as Throttle Rod
Throttle Cable
Throttle Wire Loop
(#29)
Barrel Wire Adaptor
(#30)
WIRE BARREL FOR PULLEY FIG. 5 FIG. 4
Snap-on Throttle Adaptor (#22)
Cotter Pin (#21) locks Bead
Chain to Linkage Adaptor
Throttle Clip
(#26)
-4-