Pitco Frialator Multilane Three Basket Fryer Control - Manual (Page 4)

Programming Pitco P/N 60126805
Two and Three Basket Controller
L20-403 Rev 0 07/12 4
With no cook timers running, displays will show one of the following displays: [HEATING],
[MELT] [LIQUID (or SOLID)], or [READY].
Press the [P] program key.
Left display will show [PROGRAM]. Right display will be blank.
Enter password 6684 using the product keys as numeric keypad for
entry.
Display still shows [PROGRAM].
From the [PROGRAM] display, continue with this section or go to
section 3.
NOTE: The [10] key is used whenever a 0 input is needed when
setting times or temperatures.
2.1
To Set Cook Temperature:
Press the thermometer key once.
Display shows [SET xxxF] [TEMP] or [SET xxxC] [TEMP], where .”xxx” is the temperature
setting.
Use the product keys for numeric entry, to adjust the current setting.
Press the [P] key to save setting.
Display shows [PROGRAM]; go to any other 2.x sections for other adjustments.
2.2
To Change a Product Key–Cook, Shake, Hold, and Hold Pre-Alarm Times:
For each product key Cook, Shake, and Hold times are set in this section.
With display showing [PROGRAM], continue with the following section for each product key to change.
2.2.1 Cook Time
Cook Time is set to the desired cooking time for this product key. To deactivate this product key
enter a zero value.
Press the [Clock] key.
Display shows [SELECT] [PRODUCT].
Press the desired product key to change.
Display shows [nCK mm:ss] [TIME] where “n” is the key number, “CK” means Cook, and
“mm:ss” is minutes and seconds.
Use the product keys for numeric entry, to adjust the current setting.
Press the [Clock] key to save cook time and continue setup for this product key.
2.2.2 Shake Time
Shake time is an alarm that sounds during Cook Time to prompt operators to shake the basket.
Default for this value is zero, meaning the Shake Time is inactive.
Display shows [nSH mm:ss] [TIME] where “n” is the key number, “SH” means Shake, and
“mm:ss” is minutes and seconds.
Use the product keys for numeric entry, to adjust the current setting.
Press the [Clock] key to save shake time and continue setup for this product key.
2.2.3 Hold Time
After cooking, product may stand in holding trays for a period of time. This timer produces an
alarm to inform operators to discard old product and start a new cook. Default for this value is
zero, meaning the Hold Time is inactive.
Display shows [nHD mm:ss] [TIME] where “n” is the key number, “HD means HOLD, and
“mm:ss” is minutes and seconds.
Use the product keys for numeric entry, to adjust the current setting.
Press the [Clock] key to save hold time and continue setup for this product key.
Level 1 Password