Power Soak 33529 Skewer Wash Owner's Manual - Manual (Page 18)

14
The Power Soak Skewer Wash requires routine preventive
maintenance. The following list of duties should be done on a routine
basis to ensure that the machine remains reliable:
Daily
Clean the liquid level sensors. These sensors are located on the side
walls of the wash and sanitizer tanks. They are the white plastic discs
with metal centers. Clean the sensor faces thoroughly with a washcloth
and soapy water. Removal of debris and grease is very important to
allow the sensors to function properly.
Monthly
De-lime the wash sink by adding a de-liming agent to a sink of warm,
fresh water and run the machine overnight without skewers in the rack.
Ask the chemical sales representative to recommend a specific de-
liming agent. Power Soak does not sell or provide chemicals.
IMPORTANT: Turn off the power to the unit at the
main breaker prior to performing the following task!
Clean the pump motor fan shroud with a damp, soapy rag. The motor
shroud is the "vented" cover located at the end of the motor (closest to
the control panel). This will prevent grease and dust from accumulating
in the cover's openings, which can obstruct the airflow that cools the
motor.
If there are any questions regarding the preventive maintenance
procedures, please contact the factory at 800-444-9624.
If the liquid level sensors are not cleaned regularly,
the machine may fail to operate; or it may be
possible to run it without water, which will cause
serious damage to the unit.