Vaddio AutoPresenter - Manual (Page 19)

Auto Presenter
AutoPresenter Manual 342-0029 Rev D Page 19 of 28
Menu Structure Continued
AutoTrak Input
>Select
>0 - No AutoTrak Support
>1 through 6
Identifies which input on the AutoPresenter to establish presets for the AutoTrak. RS-232 commands Can be
sent from AutoPresenter to AutoTrak when an external trigger (StepVIEW, AutoVIEW IR, PresenterPOD,
etc…) is received that references that video input port. Essentially, this feature allows the AutoTrak system to
have 6 presets when used with the AutoPresenter.
PIP Trigger
>Select
>1 through 24
Allows triggers 1 through 24 to turn the PIP stored within a preset ON/OFF - for use with Vaddio PresenterPOD
or other triggering device
PIP Trigger Mode
>Select
>
MOMENTARY
> LATCHED
Allows user to select momentary (unlatched) trigger inputs or latched trigger inputs (trigger device dependent)
Figure 9: AutoPresenter Back Panel with I/O Information
AutoPresenter I/O Connectors
Power: 12 VDC, 3A (5.5mm OD x 2.5mm ID)
Video In 1-6: HD Component (Y, Pb, Pr), RGBHV, S-Video (Y-C) or Composite (DE-15 female x 6)
Control In 1-6: RS-232C (RJ-45 F x 6)
Video Out: HD or SD Component (Y, Pb, Pr), RGBHV or * Composite (NTSC or PAL)
RS-232: DB-9F
RS-232 THRU: DB-9 M
Triggers (1-24): 14-pin Phoenix type connector (x2)
Triggers (25-72): DB-25 F (x2)
Tally Outputs: 7-pin Phoenix type connector
Network: RJ-45 F (available in a future software release)
Link In/Out: RJ-45 F (x2) For use with Precision Camera Controller Joystick
* Note: 440-5600-000 DE-15 to SD (CVBS & Y-C) breakout cable with female BNC connectors is required for NTSC
or PAL composite video