Vaddio Drop Down Series Mounts - Manual (Page 3)

©2009 Vaddio - All Rights Reserved Reproduction in whole or in part without written permission is prohibited. Specifications are subject to change
without notice. Vaddio is a registered trademark of Vaddio. All other trademarks are property of their respective owners. Toll Free: 1-800-572-2011,
Main: 763-917-4400, FAX: 763-971-4464, www.vaddio.com Document Number 341-676 Rev. D
Step 5:
For Suspended Ceiling Installations: Slide the pipe with 5” flange end through the hole in the ceiling tile. Place
the 5” washer onto the threaded pipe, and screw the hex nut onto the pipe thread and tighten the hex nut down,
then thread the Jam Nut onto the top of the pipe and tighten it to the hex nut (see Figure 5). Carefully feed the
Cat. 5 cabling through the pipe and the cable pass-thru at the back of the camera mount.
For Drywall Ceiling Installations: Once you have installed appropriate mounting hardware for the flange, carefully
pull the Cat. 5 cabling through the 1” hole in your drywall ceiling. Thread the cabling through the pipe, and pull it
through the cable pass thru at the back of the camera platform. Place the flange on the ceiling and tighten the
screws down onto the mounting hardware.
Figure 4: Camera Platform Mount Detail Figure 5: Ceiling Mount Detail
Step 6:
Place your camera onto the mount and secure it to the camera platform using the supplied black screw(s).
Connect the Cat. 5 cabling to the back of the camera and carefully feed excess Cat. 5 cabling back into the ceiling.
IMPORTANT NOTE: Use only the provided 3/8” long 1/4”-20 screws with the HD-20
Drop Down Series
Small Platform - 12” Pipe Camera Mount
(535-2000-290)
Drop Down Series
Large Platform - 12” Pipe Camera Mount
(535-2000-292)
Includes:
 One (1) Drop Down Small
Platform Ceiling Mount with
12” Pipe (fits Sony EVI-D70,
EVI-D100, Canon VC-C50i,
Polycom PowerCam and
LifeSize cameras)
 One (1) 1/4”-20 screw for
mounting the PTZ cameras
described above
 One (1) Ceiling Tile Support
Brace
 Install Guide
(Camera not included)
Includes:
 One (1) Drop Down Large
Platform Ceiling Mount with
12” Pipe (fits Sony EVI-HD1,
Polycom EagleEye and
TANDBERG Precision HD
cameras)
 Four (4) – 3mm black screws
for mounting the EagleEye
camera
 One (1) – 1/4”-20 screw for
mounting Precision HD or
EVI-HD1 PTZ Camera
 One (1) Ceiling Tile Support
Brace
 Install Guide
(Camera not included)
5” WASHER
MOUNTING FLANGE