Vaddio EasyUSB PRO MIC I/O - Manual (Page 12)

PRO MIC I/O
Vaddio PRO MIC I/O - Document Number 342-0569 Rev A Page 12 of 16
F IRMWARE U PDATES
The PRO MIC I/O can be upgraded in the field with the use of the Vaddio Loader software application. The Audio
is updated using the Vaddio Loader connected to the EasyUSB Mixer/Amp in the same method used for the
EasyMic devices. The process for firmware updates follows:
UPDATING PRO MIC I/O (Audio):
Step 1: If uncertain about updating or upgrading the equipment, please contact Vaddio
Technical Support first. There is a possibility that any device can be turned into a brick, so
please give Tech Support a call first to get the “real” dos and don’ts of updating.
Step 2: Place DIP Switch 8 in the UP position on the EasyUSB Mixer/Amp. This places the system in firmware
update mode. Power Cycle the unit after enabling DIP switch. Make sure the PRO MIC I/O is connected to
EasyUSB Mixer/Amp.
Step 3: Launch VaddioLoader and select Audio as Product Type. In the drop down list go to PRO MIC I/O
(Audio). Select desired firmware file to be updated and then press start.
Step 4: The Vaddio Loader will notify when the firmware update is complete. Upon completion, place the
EasyUSB Mixer/AMP DIP 8 to the down position and reboot the unit. The Firmware update will be complete after
rebooting.
Please do not interrupt the updating process while it is running. Generally, it’s never a great idea
to interrupt any updating/upgrading process, so please remain both calm and patient.
Uncertain?