Vaddio Image Controller CeilingVIEW HD-18 DocCAM - Manual (Page 5)

CCU Image Controller for CeilingVIEW HD-18 DocCAM
CCU Image Controller for CeilingVIEW HD-18 DocCAM - Document 342-0197 Rev. A Page 5 of 12
CCU Image Controller Rear Panel Connections (left to right):
Power Input:
5.5mm OD x 2.5mm ID, Positive Center 12 VDC, 1.0 Amp, Power Jack
Use with Provided 12 VDC, 1.0 Amp Power supply only.
RS-232 IN:
Control input from Joystick Controller (i.e. Precision Camera Controller, ProductionVIEW HD, etc…), control
system or codec. This input provides for camera control other than CCU controls.
RS-232 OUT
(To Camera):
Attach to CeilingVIEW HD-18 DocCAM’s RS-232 Port for CCU Control.
Tally Contact:
Local front panel tally - lights up Blue LED on front panel when shorted.
Camera Settings:
10-position dip switch for added functions and future control parameters.
Instructions for using the CCU Image Controller:
Power-Up Order:
When using the CCU Image Controller, power up the CeilingVIEW HD-18 DocCAM first, the
CCU Image Controller second, and lastly the control system (ProductionVIEW HD, AutoPresenter, Precision
Camera Controller, etc...). The CCU Image Controller and Vaddio camera controllers will auto-detect the camera
attached, so naturally the CeilingVIEW has to be ON first.
Monitor Set Up:
Verify that the video monitor used in conjunction with the CCU Image Controller is set up
correctly and is delivering accurate color reproduction.
Initial CCU Set Up:
 Adjust the Iris level of the camera so that brighter areas are not washed out.
 Adjust the Pedestal level so that the black levels are not too dark, and not too light.
 When those levels are set, adjust the Red & Blue Gain, Gamma, Detail, Knee and Chroma.
 NOTE: Gain (next to Iris) should be left at zero (0) unless lighting is inadequate, then turn it to a level where
the signal brightness is at an appropriate level. Higher Gain levels add additional noise (grain) to the video
signal.
.