Vaddio HuddleSTATION - Manual (Page 16)

HuddleSTATION
Vaddio HuddleSTATION - Document Number 342-0692 Rev B Page 16 of 44
Step 3: Hang the Camera/Sound Bar on the Wall Bracket
Remove end-caps from the Camera/Sound Bar. The left end cap houses the connectors for Power, Network,
LINK, and HDMI out. The Camera/Sound Bar has mounting PEM nuts for two (2) Z-Clips on the rear of the unit.
Attach the provided Z-Clips to the back of the Camera/Sound Bar with the provided 8-32 x 5/16” Phillips pan head
screws. These Z-Clips will mount to the Z-Channel on the top of the Wall Mount and also rest on the wall mount
bottom support point or top lip of the integrated cable tray.
Diagram: Rear of the Camera/Sound Bar showing the location of the Z-Clips
Remove the end-caps before mounting the Camera/Sound Bar to the Wall. The end-caps are mounted with balls
and sockets and are easily removed.
Diagrams: Mounting the Z-Clips on the Z-Channel
Mount the Z-Clips on the Camera/Sound Bar onto the Z-Channel of the Wall Mount
Z-Clips mounted to
back of the
Camera/Sound Bar
Remove the
End-caps
REAR VIEW
Remove the
End-caps
Wall Mount attached
to wall with anchors
and screws
Camera/Sound Bar left side shown without end-caps revealing
connector panel and the end of the speaker. Place the Z-Clips on
the Z-Cannel.
Camera/Sound Bar Z-Clips lowered
down to lock on top of the Z-Channel
The top of the cable
tray supports the
bottom of the enclosure.
PEM Nut for Safety/Seismic Strap *
Speaker Speaker
Grill
Z-Channel
Wall anchors
and screws
Socket X 4 that holds
the snap on end-cap
HDMI
TO
MONITOR
TO DOCK
NETWORK
24 VDC
3.0 A
LINK
HDMI
TO
MONITOR
TO DOCK
NETWORK
24 VDC
3.0 A
LINK
* PEM nuts on the front (center) of the cable tray and the
bottom (center) of the Camera/Sound Bar are provided to
allow attachment of a woven nylon safety strap to address
security and seismic stability.