Vaddio HuddleSTATION - Manual (Page 41)

HuddleSTATION
Vaddio HuddleSTATION - Document Number 342-0692 Rev B Page 41 of 44
Under the RTP Settings Tab the RTP Port Range, the Codec Priority and the Audio Processing parameters are
defined. The following information is required for the RTP Settings tab:

RTP SETTINGS
Port Range:
(Sets RTP port range used for audio transports)
 CODEC PRIORITY
❒
G.722 HD - Wideband
❒
G.711µLaw
❒
G.711aLaw
(The first in the list will be used for call negotiation)
 AUDIO PROCESSING
DTMF Relay:
❒
(For using DTMF in band - Click to Enable)
DTMF ON Time:
(Default 150ms 0 - Sets DTMF timing)
DTMF OFF Time:
(Default 50ms - Sets DTMF timing)
VAD Enabled:
❒
(Check to Enable - Voice Activity Detection) Used for
bandwidth management.
VAD Threshold: (Default -45dBu - minimum level that voice has to be in
order to be detected)
Comfort Noise Enabled:
❒
(Check to Enable) Synthetic background noise used to fill
the artificial silence of digital
Comfort Noise Threshold:
(Default -63dBu)
Silence Suppression:
❒
(Check to Enable - With VAD on, Silence Suppression
works to reduce call bandwidth when no voice is detected)
(In most cases, the defaults should be adequate.)
For the 3
rd
HuddleSTATION IP Address (PC):
The 3 rd and final IP Address is for the in-room PC or laptop (BYOD) that is running the chosen UC application.
The courtesy network jack on the MicDock can be used by the room PC, or any other network jack in the room
that is on the same network as the HuddleSTATION.
As always, it is very important from to work closely with the IT professionals at the place of installation to
acquire the IP addresses, the required VoIP information and the network jack(s) required to install and
operate each HuddleSTATION.