Vaddio OneLINK - Manual (Page 7)

OneLINK
OneLINK for Cisco Precision HD Cameras - Installation and User Guide 342-0122 Rev. G Page 7 of 12
Step 6:
Attach the PrecisionHD camera to the mount with the provided ¼” x 20 screw, tie up the cables neatly and
connect the Cat-5e cable from the head end to the connector labeled OneLINK as shown below.
Step 7:
At the head end, connect the Cat-5e cable from the camera location to the OneLINK port on the Quick-Connect
OneLINK port as shown above.
Step 8:
From the Quick Connect OneLINK, connect the HDMI output to the desired codec input. Use the provided 9-Pin
RS-232 to RJ-45 adapter to connect the camera control port on the codec to the camera control port on the
OneLINK with a Cat-5e cable as shown below.
Do not use the Cisco/TANDBERG DB-9M to RJ-45 Cable #
116627 to make this connection.
OneLINK Cat-5e
Up to 125’ (38.1m)
Camera
Location
Head End Location
Cat-5e Patch Cable
(Not Supplied)
Do not use the
Cisco/TANDBERG
Cable # 116627 to
make this connection
HDMI Cable
(Not Supplied)
Provided RS-232 to
RJ-45 Control Adapter
(Camera Control Port)
RS-232
Cat-5e not
provided Cisco C60
Do not use cable
#116627 supplied
with the codec on
this Camera Control
Port