Vaddio ProductionVIEW HD - Manual (Page 13)

ProductionVIEW HD
ProductionVIEW HD Manual 341-759 Rev. C Page 13 of 24
Master Power, Manual and Auto Modes (continued)
Master Power Switch
• When the Master Power Switch is powered down, all of the attached cameras will be placed in
standby. Press and hold the power switch for 3 seconds to initiate power down sequence. This is
a safeguard to prevent accidental shutdown.
• When the Master Power Switch is powered up, all attached cameras will activate and select
default camera and preset information as defined in the menu. The ProductionVIEW HD will scan
the inputs for camera type and video signal type and auto-configure accordingly. This can take
up to one minute and is normal operation.
• Note: When the camera control ports are changed or reconfigured, the “Rescan Cameras” option
in the menu must be selected and started to rescan the cameras and reload the proper control
codes
. If only the video inputs are changed, then activate the Rescan Video function in the Main
Menu to reset the video input priorities.
ProductionVIEW HD Menu Structure
The ProductionVIEW HD has an 8-line LCD that displays the system menus. The menus are traversed
with the up/down arrows, select and cancel buttons. The menu structure is as follows:
1 st Screen ProductionVIEW HD
V01.00.00 (software version)
Rescan Cameras
Video Output
Video Input
Default Camera
Focus Near
Rescan Cameras
>Select (Note: Rescans all RS-232 ports for camera inputs)
>Start
Rescan Video
>Select (Note: Resets all inputs, outputs and video processor)
>Start
Video Output Menu
>Select
>Video Output
>Program Output
HD 1080p 59.94 Hz
HD 1080p 50 Hz
HD 1080i 59.94 Hz
HD 1080i 50 Hz
HD 720p 59.94 Hz
HD 720p 50 Hz
HV 640 x 480 - 60 Hz
HV 640 x 480 - 75 Hz
HV 800 x 600 - 60 Hz
HV 800 x 600 - 75 Hz
HV 1024 x 768 - 60 Hz
HV 1024 x 768 - 75 Hz
HV 1280 x 768 – 60 Hz
HV 1280 x 1024 - 60 Hz
HV 1366 x 768 – 60 Hz
HV 1400 x 1050 – 60 Hz
HV 1600 x 1200 – 60 Hz
HV 1920 x 1200 – 60 Hz
SD NTSC S-Video
SD PAL S-Video
SD NTSC Composite
SD PAL Composite
>Preview Output (NOTE: Same resolution options as Program Output menu)
Menu Section