Vaddio ProductionVIEW HD - Manual (Page 15)

ProductionVIEW HD
ProductionVIEW HD Manual 341-759 Rev. C Page 15 of 24
Select Follow Preview
>Select
>On or Off
When activated, camera selection switching follows the Preview bus selection, immediately transferring joystick
and camera control directly to the camera selected on the Preview bus (On is default). NOTE: This function
only works in Single Bus Mode – and not in Dual Bus Mode.
Cam Search Menu
>Select
>All Ports: (select search method – Auto, Sony, Canon, Panasonic)
>Port 01: (select search method – Auto, Sony, Canon, Panasonic)
>Port 02: (select search method – Auto, Sony, Canon, Panasonic)
>Port 03: (select search method – Auto, Sony, Canon, Panasonic)
>Port 04: (select search method – Auto, Sony, Canon, Panasonic)
>Port 05: (select search method – Auto, Sony, Canon, Panasonic)
>Port 06: (select search method – Auto, Sony, Canon, Panasonic)
NOTE: When using Panasonic HE100 cameras, you must select Panasonic.
CCU Mode
>Select
>All Ports: (Select method – Direct Cam Ctrl or CCU)
>Port 01: (Select method – Direct Cam Ctrl or CCU)
>Port 02: (Select method – Direct Cam Ctrl or CCU)
>Port 03: (Select method – Direct Cam Ctrl or CCU)
>Port 04: (Select method – Direct Cam Ctrl or CCU)
>Port 05: (Select method – Direct Cam Ctrl or CCU)
>Port 06: (Select method – Direct Cam Ctrl or CCU)
NOTE: When Vaddio Quick-Connect CCUs are used with ProductionVIEW HD, CCU mode disables Iris
functions, AWB and BLC on the ProductionVIEW HD console, allowing the user to control these functions from
the Quick-Connect CCU)
System Menu
>Select
>Serial Input
>Select
>Yes
or No
Turns on or off serial input (default is Yes)
>Serial Echo
>Select
>Yes
or No
Turns Serial Echo on or off (default is Yes)
>Serial Info
>Select
>On
or Off
Reports button pushes on front panel out the serial port (default is Off)
(Does not report joy stick position)
>Panel Lights
>Select
>00
through 50
Panel Light Brightness (all lights - 50 is the brightest) (default is 25, off is 00)
>Clear Memory
>Select
>Start
Clears the camera preset memories and sets all parameters to default settings
>Clear Presets
>Select
>Start
Clears the camera preset memory only
>Power Up Preset
>Select
>Home
Camera
>Select - Upon power up, all cameras will go to their home position
>Preset 12
> Select - Upon power up, all cameras will go to Preset 12