Vaddio Sony EVI-HD1 PTZ Camera - Manual (Page 7)

7
Locations of Controls
1 CAMERA SELECT buttons
Press the button corresponding to the camera you want to
operate with the Remote Commander.
The camera number can be set using the IR SELECT switch
on the rear of the camera.
Note
If two or more cameras are adjacent and have the same
camera number, they are operated simultaneously with the
same Remote Commander. When you install the cameras
close to each other, set different camera numbers.
For the camera number setting, see “Operating Multiple
Cameras with the Remote Commander” described in the
Operating Instructions supplied with the camera.
Remote Commander
2 FOCUS buttons
Used for focus adjustment.
Press the AUTO button to adjust the focus automatically.
To adjust the focus manually, press the MANUAL button,
and adjust it with the FAR and NEAR buttons.
3 DATA SCREEN button
Press this button to display the main menu. Press it again
to turn off the menu. If you press the button when a lower-
level menu is selected, the display goes back to a higher-
level menu.
Note
Pan/tilt operations are disabled when the menu is
displayed.
4 PAN-TILT buttons
Press the arrow buttons to perform panning and tilting.
Press the HOME button to face the camera back to the
front.
When the menu is displayed, use
V or v to select the menu
items and B or b to change the set values. The selected
setting menu is displayed, by pressing the HOME button
when the main menu is displayed.
5 L/R DIRECTION SET button
Hold down this button and press the REV button to change
the direction of the camera movement opposite to that
indicated by the arrow of the
B/b buttons.
To reset the direction of the camera movement, press the
STD button while holding down this button.
6 POWER switch
Press this button to turn on/off the camera when the
camera is connected to an AC outlet.
7 BACK LIGHT button
Press this button to enable the backlight compensation.
Press it again to disable the backlight compensation.
8 POSITION buttons
Hold down the PRESET button and press button 1 to 6 to
store the current camera direction, zooming, focus
adjustment and backlight compensation in the memory of
the pressed number button.
To erase the memory contents, hold down the RESET
button and press button 1 to 6.
9 PAN-TILT RESET button
Press this button to reset the pan/tilt position.
0 ZOOM buttons
Use the SLOW button to zoom slowly, and the FAST
button to zoom quickly.
Press the T (telephoto) side of the button to zoom in, and
the W (wide angle) side to zoom out
2 Switch 2 (Communication baud rate selector)
Set to ON for 38400 bps, or OFF for 9600 bps.
Note
Set the communication baud rate before turning on the
power. If you set the communication baud rate after
turning on the power, the setting is ignored.
3 Switch 3 (Not used)
Be sure to set this switch to OFF.
4 Switch 4 (Not used)
Be sure to set this switch to OFF.
qg Tripod screw hole (1/4-20UNC)
qh Fixing screw holes (M3)