Vaddio UXHD CrossPoint User Manual
Page 2
UXHD CrossPoint
UXHD CrossPoint Installation and User Guide 341-929 Rev. A Page 2 of 12
INFORMATION
For RS-232 control information, please see the index at the back of this manual. Vaddio has also prepared a
number of TechNotes, specifications and drawings designed to inform and educate integrators on the value
and the specific uses of Vaddio products.
UNPACKING
Carefully remove and identify the following parts for the UXHD CrossPoint system:
• One (1) - Vaddio UXHD CrossPoint (1-RU Enclosure)
• One (1) - EZCamera™ Control Adapter (RJ-45 to DB-9)
• One (1) - 12VDC, 3A PowerRite™ Power Supply with AC Cord Set
• Install Guide
TECHNICAL HIGHLIGHTS
Vaddio uses only the most advanced electronics available today to provide flexible, functional and high
quality products and the UXHD CrossPoint is no exception. The UXHD uses a 3Gb/s capable HD-
SDI/SDI
receiver and transmitter on Input 2 and Output 2 which generates SMPTE 424M, SMPTE 292M, SMPTE
259M-C compliant serial digital output signals. The 3Gb/s receiver and transmitter ensure the ability to use a
single link (with a single coax cable) connection at HD-SDI resolutions up to and including 1080p/60Hz which
is 100% compatible with Vaddio’s other 3Gb/s HD-SDI products available today. In order to achieve the
1080p/60 resolution,
circuit board edge mount (3Gb/s compliant) carrier class BNCs with gold finish body
and contacts are also used for the HD-SDI I/O and the external reference input for the HD-SDI as well.
Quick-Connect CCU Front Panel Controls (left to right) Figure 2:
Menu:
The Select, Cancel, Up and Down Arrows allow the user to navigate through the menu to select the
input and output signals and other parameters that are displayed on the LCD screen. These keys are not
back lit.
Input/Output Buttons:
After the UXHD is programmed, selecting an input button illuminates which output(s)
are active for that input.
Power Button:
Pressing the button will start the system. To turn off the UXHD, push and hold the Power
button for approximately 2.0 seconds.
Rear Panel Connections and Controls (Left to Right) Figure 3:
Power Supply Input:
12VDC, 3.0 Amp power supply on a 5.5mm OD x 2.5mm ID connector.
Input 1:
DE-15 (D-sub HD-15) Connector for analog component YPbPr or Y/C and CVBS* or RGBHV
Input 2:
BNC connector for HD-SDI/SDI video.
Output 1:
DE-15 (D-sub HD-15) Connector for analog YPbPr or Y/C and CVBS* or RGBHV
Output 2:
BNC connector for HD-SDI/SDI video
External Reference:
BNC connector for synchronizing Output 2 to a third-party device that requires a
synchronized source
RS-232:
DB-9 connector for allowing UXHD CrossPoint to be controlled from a third-party device
*Standard Definition Y/C and CVBS requires the SD Adapter Cable, Part Number 440-5600-000 (DE-15M to 3-BNC-F)
+
G
12 VDC
3.0 A