Vaddio UXHD CrossPoint - Manual (Page 9)

UXHD CrossPoint
UXHD CrossPoint Installation and User Guide 341-929 Rev. A Page 9 of 12
Appendix 1: Communication Specification and Pin-outs for the UXHD CrossPoint
Vaddio uses simple control protocols to accomplish custom programming with the ProductionVIEW HD. The
Communication Specification, API and Programming Language are listed below and definitions are listed on
the next page. Note: All commands must be followed by a carriage return.
Communication Specification Control Port - RS-232 on DB-9F Connector
Communication Speed: 9600 bps (default)
Start bit: 1
Stop bit: 1
Data bits: 8
Parity: None
No Flow control PIN# Signal
2) TXD
3)
RXD
5) GND
All other pins - Unused
API and Programming Language
+----------------------------------------------------------------------------+
| Vaddio UXHD CrossPoint |
+----------------------------------------------------------------------------+
|? - This menu |
+--------------- System -----------------------------------------------------+
|Power x- Power(On/Off) |ClearMem - Clear Memory |
|SerialEcho x- Echo Serial (Yes/No) |Reset - 'CPU'Reset |
|Version - Firmware Version |Config - List Config Settings|
|EEDump - Display Config EEProm | Input x- Input (1/2) |
| | Output x- Output (1/2) |
+----------------------------------------------------------------------------+
Command Structure Definitions
Command Parameters Description
ClearMem ClearMem(cr) Clear Memory
Config Config(cr) Display system configuration
EEDump EEDump(cr) Display Configuration EEProm
Input Input 1/2(cr) Select Input port
Output Output 1/2(cr) Select Output port
Power Power On/Off(cr) Power system On/Off
Reset Reset(cr) Soft System reset
SerialEcho SerialEcho On/Off(cr) Serial Echo On/Off
Version Version(cr) Display System Version information