Vaddio WallVIEW 70 - Manual (Page 4)

Vaddio WallVIEW – Document Number – 010-2201-000 Rev. F
Page 4 of 8
MOUNTING
INSTRUCTIONS Step 1:
After determining the optimum location of the camera system, route the Cat. 5
cabling from the camera to the Quick-Connect Box located at the head-end. The
cable should pass through the oval slot located on the rear flange of the wall
mount (Figure 4).
Be sure to leave several inches of Cat. 5 extending out from the wall for ease of
connection.
Step 2: If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with
the wall box cover plate to attach the Thin Profile wall mount bracket. If the
bracket is to be mounted to the dry wall, then mark and drill 3/16” (4.76mm) holes.
Make sure that the holes line up and provide a level, flat mounting surface. Tap in
the four (4) provided plastic conical wall anchors and mount the wall mount to the
anchors with the supplied sheet metal screws.
Step 3: Carefully attach the Vaddio EZCamera Shoe to the back connector plate of the
camera. Note: Do not force, the shoe should slide into place and make positive
connection with a minimum of effort.
Step 4: Place the camera onto the camera mount and plug in the Cat. 5, RJ-45
connectors. Using the supplied ¼”-20 machine screw, secure the camera to the
mount through the mounting slot (see Figure 4). Gently push camera back
towards the rear of the mount, feeding the excess cable into the wall or wall box,
until the shoe is held up against the wall mount, then tighten bottom screw.
Figure 4:
Wall Mount bracket showing oval cabling
through-hole on back of mounting flange.
Mount may be mounted to the wall with
conical wall anchors or to 2-gang wall box
Figure 5:
WallVIEW 70 shown with EZCamera
Cable Shoe. Carefully slide the shoe
into place taking care to seat the
male connections firmly into place.
Press firmly into place
Figure 6:
WallVIEW 100 shown with camera
shoe and mount. Slide the camera
and shoe back to touch the shoe and
mount together, then tighten ¼”-20
screw.
¼”-20 mounting screw
through bottom slot
Press to back of mount
Slide camera to back of mount and tighten