Vaddio WallVIEW 70 - Manual (Page 5)

Vaddio WallVIEW – Document Number – 010-2201-000 Rev. F
Page 5 of 8
Step 5: Attach the Cat. 5 cable for Power and Video on the Quick-Connect Box. Use the
supplied Video cables and plug these cables from the Quick-Connect Box to the
video destination (codec, monitor, projector). Connect the PowerRite power
supply to the Quick-Connect Box power input (see Figure 2).
Step 6: Verify all connections. Please check all Cat. 5 cables for continuity in advance to
final connection. This will save hours of trouble shooting time.
Connect only the Vaddio supplied power supply to an AC outlet. Power will travel
down the Cat. 5 cable to the cable shoe, powering the camera. The camera will
“Home” to a centered position ready for control information from the provided
Vaddio IR Remote Commander (WallVIEW 70, 100) or Canon IR Remote
(WallVIEW 50i PTZ) or RS-232 Camera controller of the integrators’ choice.
Completing the
Installation
To insure proper continuity of control and operation of the cameras, the RS-232
controller (control system or joystick) should be powered on after the cameras.
The cameras should be powered up first in the control line. Depending on how
your programs are written, and if the cameras are turned off every night, please
adhere to the described power–up order to ensure proper operation.
INFORMATION For documents on video, power and control pin-outs, please see the Vaddio
website under Vaddio Technical Note #101 or the Appendix at the back of this
manual.
For RS-232 control information, please see the full-length manuals for each of the
manufacturer’s camera models (Sony EVI-D100, EVI-D70 and Canon VC-C50i)
either on the Vaddio or the manufacturer’s website
www.vaddio.com .
Vaddio has prepared a number of TechNotes, specifications and drawings
designed to inform and educate integrators’ of the value and the specific uses of
Vaddio products.
CARE AND
CLEANING
• Do not attempt to take the products in these systems apart. There are no
user-serviceable components inside.
• Do not spill liquids on the products
• Keep these devices away from food and liquid
• For smears or smudges on the lens, wipe with a clean, soft cloth. Do not use
any abrasive chemicals on the camera body at any time.
OPERATING AND
STORAGE
CONDITIONS Do not store or operate the WallVIEW System under the following conditions for
any circumstance:
• Temperatures above 40°C (104°F)
• Temperatures below 0°C (32°F)
• High humidity, condensing or wet environments
• Dusty environments
• In inclement weather
• Under severe vibration