Vaddio WallVIEW CCU 300 Quick-Connect - Manual (Page 5)

Quick-Connect CCU 300
Quick-Connect CCU 300 Installation and User Guide 341-741 Rev. B Page 5 of 12
INSTALLATION
All Quick-Connect products are specifically designed for installation on a vertical wall surface with CAT-5
cable connectivity for Power, Video and Control signaling. Installation is simplified in that no custom 8-Pin
mini-din cables or expensive S-Video plenum cables are needed and no power outlets are required near the
camera bracket. All cabling is routed to the head-end using CAT-5 cables.
Before Installing
• Find the appropriate camera mounting location, paying close attention to camera viewing angles, lighting
conditions, possible line of site obstructions, and checking for in-wall obstructions where the camera is to
be mounted. Pick a mounting location to optimize the performance of the camera.
• Pre-wire all cabling as required (see wiring diagram examples).
• The Thin Profile Wall Mount for the Quick-Connect CCU 300 can be mounted directly to a 3-gang wall
box or can be mounted to the drywall using four dry wall anchors.
MOUNTING INSTRUCTIONS
Step 1:
After determining the optimum location of the CCU system, mark locations for the four screw holes and cable
pass-thru (vertical oval). Install the drywall mounts and cut the hole for the cable pass-thru. At this point, do
not install the Wall Mount.
Step 2:
Connect the 25-pin cable to the the EZIM CCU. Next, mount the EZIM CCU and break out cable on the back
of the wall mount, using the two tapped screw holes (see Figure 4).
Figure 3:
Thin Profile Wall Mount with oval cable feed-through hole.
The wall mount may be mounted directly to a 3-gang wall
box or to drywall with the appropriate wall anchors.
Figure 4:
25-pin connector mounted
to EZIM CCU (left) and
EZIM CCU mounted to the
Wall Mount (right)