Vaddio WallVIEW CCU H900 User Manual

Page 10

Advertising
background image

Quick-Connect CCU Kit for BRC-H900 Camera

© 2012 Vaddio - All Rights Reserved. Document Number 342-0507 Rev A Page 10 of 16

Step 3:
Take the Wall Mount, with the EZIM CCU and break out cable installed, and place it against the drywall anchors
or 3-gang wall box, making sure to pull the three Cat-5 cables through the oval pass-through hole. Finger-tighten
the screws to the mount and confirm that the base is level. Tighten the screws firmly. If the bracket is to be
mounted on a 3-gang wall box, use the screws supplied with the electrical box.

Step 4:
Confirm that the Cat. 5 cables are terminated correctly, by testing them with a continuity tester. Connect the
break out cables to the appropriate ports on the BRC-H900 (8-pin Mini DIN is connected to VISCA IN). Push the
camera into place and dress the cables. Secure the camera to the mount and using the ¼”-20 screws.

Step 5:
The Quick-Connect CCU is a 1-RU rack mount interface that breaks out the signals from the Cat. 5 cables back
to the standard connectors. Connect the other side of the appropriate Cat-5 cable to the CCU except for power.
The basic system connectivity is illustrated below.

Drawing: Basic System Connectivity

Wiring Diagram Example:


































System Configuration Notes:

The Quick-Connect CCU System uses a Cat-5 (all 4-pairs) for power to ensure the motors receive the required current to operate properly.
The Video Cat-5 cable uses all four pairs for video. The RS-232 Cat-5 provides communication to the camera for CCU and PTZ control and
G/L (where applicable) to the camera. These Cat. 5 cables can be run up to 500’ (152.4m). See Appendix 1 for wiring and pin-out
information. NOTE: Daisy-Chain configurations are not supported.


Cat-5 Cables

up to 500’

HD Break-out

Cable

EZIM CCU Top Panel

Power

RS-232 & G/L

HSDS Video on Cat-5

RS-232

Tally

ProductionVIEW HD

HD-YPbPr Out

RS-232

CVBS

G/L

POWER

Quick-Connect CCU

BRC-H900 Camera, Wall Mount
with EZIM CCU (behind camera)
Note: Camera not included

HD YPbPr

+

G

Composite

Video

Simulated Video Feed

HD Video

G/L Box

Advertising