Vaddio WallVIEW CCU H900 - Manual (Page 9)

Quick-Connect CCU Kit for BRC-H900 Camera
© 2012 Vaddio - All Rights Reserved. Document Number 342-0507 Rev A Page 9 of 16
Step By Step Mounting Instructions:
Step 1:
After determining the optimum location of the camera system, mark locations for the four screw holes and cable
pass-thru (vertical oval). Install the drywall mounts and cut the hole for the cable pass-thru. At this point, do not
install the Wall Mount.
Image: Heavy duty wall mount
The wall mount may be mounted directly to a 3-gang wall box or to drywall
with the appropriate wall anchors.
Step 2:
Connect the break out cable to the EZIM CCU. Mount the EZIM CCU and break out cable in the back of the wall
mount, using the supplied screws and two tapped screw holes.
Image: Heavy Duty Wall Mount
Wall mount shown with EZIM CCU and HD break out cable attached to the
back of the mount.
Drawing: High Definition Break Out Cable
DB-25-M
plugs into
EZIM CCU
12 VDC Power
on EIAJ-04
RS-232 on
8-pin Mini Din-M
CVBS on
BNC-M
G/L on
BNC-M
YPbPr on
DE-15-M