Vaddio WallVIEW HD-18W DVI/HDMI w/CONCEAL - Manual (Page 8)

WallVIEW HD-18 DVI/HDMI
©2011 Vaddio - All Rights Reserved. WallVIEW HD19 DVI/HDMI, Document Number 342-0045 Rev. C Page 8 of 16
Mounting and Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location
Note: When locating the camera, consider viewing angles, lighting conditions, possible line of site
obstructions and check for in-wall obstructions where the camera is to be mounted. Pick a mounting
location to optimize the performance of the camera.
The 2 (two) Cat-5e cables should feed-through a 1” (25.4mm) opening (circular or square shape)
centered in the rectangular slot located on the rear flange of the CONCEAL Wall Mount Bracket (see Fig.
1).
Note: Do not cut out the entire rectangular slot opening in the wall! This will not allow the two (2)
lower wall anchors to correctly fasten the Conceal Wall Mount to the wall.
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover
plate to attach the CONCEAL Wall Mount Bracket.
If mounting to drywall with wall anchors, use the four (4) quality wall anchors/screws provided (see Fig. 1).
Note: The mounting holes are slotted and are 90° opposing to provide easy leveling. Level the mount
and tighten the mounting screws.
Step 2: System Connectivity:
1) Use the accompanying HD-18 manual to set the switch settings for HD video out resolution, IR
frequency and output, baud rate, SD video format and shape, image orientation etc…
2) See “Connectivity Example 1” on page 6. This is the basic two (2) Cat. 5e cable system where Power
is sent to the camera and HD Video is returned from the camera on one Cat. 5e (blue line) and RS-
232 control communication and IR feed-through is returned from the camera (dashed grey line):
a. Connect the first Cat 5e cable from the EZCAMERA POWER & HD VIDEO RJ-45 jack on the
Quick-Connect to the EZ POWER VIDEO RJ-45 jack on the back of the camera
b. Connect the 2
nd
Cat 5e cable from the RS-232 CONTROL “TO CAMERA” port to the RS-232
IN/IR OUT jack on the back of the HD-18 camera. Connect the control source (i.e. Vaddio’s
Precision Camera Controller, ProductionVIEW HD, ControlVIEW™ XHD, AutoPresenter™
etc…) to the RS-232 CONTROL INPUT.
c. Connect the DVI-D output to a DVI-D video device (or HDMI with a DVI-D to HDMI adapter
cable - sold separately) and/or connect the YPbPr output to a different video destination
device. Both the DVI-D and the YPbPr are live images at the same resolution which is set at
the camera. The only difference is that the DVI-D signal is digital and the YPbPr is analog.
Both are capable of 1080p/60Hz.
d. Check all Cat 5e cables for proper connection and check the cables for continuity in advance
of final connection. Please do not use the “feed-thru” or “EZ” type RJ-45 connectors for
professional installations (see page 3 for Important Safeguards).
Note: Plugging the EZCAMERA POWER & HD VIDEO Cat 5e cable into the wrong
RJ-45 may cause damage to the camera system and void the warranty.
Fig. 1: CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall