Vaddio WallVIEW HD-22 and WallVIEW HD-30 - Manual (Page 11)

WallVIEW HD-22 and HD-30 SR Systems
WallVIEW HD-22 and HD-30 SR Cameras Systems - Document Number 342-0643 Rev A Page 11 of 20
Step 3: Secure the Camera To the CONCEAL Wall Mount Bracket
After all cables are attached to the camera, place the camera onto the camera mount and insert the two 1/4”-20
screws into the camera through the two-screw slots in the bottom of the mount. Note: Be sure to align each side
of the camera evenly for the best fit prior to tightening the mounting screws.
Step 4: Install the CONCEAL Lower Cover Plate
Attach the CONCEAL lower cover plate. Slide the lower cover plate from front of the mounting bracket toward the
rear of the bracket. The two (2) rear locking tabs will need to be guided into position first and will lock in place as
the lower cover plate is pushed toward the rear of the mounting bracket. The two (2) front tabs will engage as the
cover is pushed back into place.
Step 5: Install the CONCEAL Rear Camera Cover
Install the CONCEAL rear camera cover on the mounting bracket with the supplied screw.
NOTE (One more time!): Verify that the Cat-5 cables are plugged in correctly. Plugging
the Power/Video cable into the wrong RJ-45 jack may cause damage to the camera system
and void the warranty.
Step 6: Connect System Power
Connect the 24 VDC power supply to the Quick-Connect SR Interface and to an AC outlet. The SR will power the
camera via the Power/Video Cat-5 cable. The camera will “Home” to a centered position and will output video
when it has completely booted up. The WallVIEW is now ready for control information from the controller or IR
Remote Commander.
A Note on Boot Order: When using a joystick controller or external control system, in order
to ensure proper continuity of control and operation of the cameras, the RS-232 controller
should be powered-on after the camera. In most, if not all cases, the camera needs to be on
and running in order for communication to take place between the camera and controller.
When plugging a new camera into a RS-232 controller/joystick that has already been powered
up, a system reboot or camera rescan may be necessary to find the camera.
CONCEAL Lower Cover Plate
with Locking Tabs
CONCEAL Lower Cover
Plate locked in place
CONCEAL Rear Camera Cover
Completed CONCEAL Wall Mount
Camera Bracket Installation