Vaddio WallVIEW PRO Z330 - Manual (Page 3)

WallVIEW PRO Z330 Installation and User Guide 341-907 Rev. A Page 3 of 12
Daisy Chain Control Configuration:
The WallVIEW PRO Z330 has provisions for daisy chaining control signals when using a RS-232 controller
with only one (1) RS-232 output. Each WallVIEW PRO EZIM has a RS-232 input and a RS-232 output (see
Figure 3).
MOUNTING INSTRUCTIONS
Step 1:
After determining the optimum location of the camera system, route the required 3 (three) Cat. 5 cables from
the camera to the Quick-Connect Pro interface located at the head-end. The three Cat. 5 cables should
feed-through the oval slot located on the rear flange of the wall mount (Figure 4). If the bracket is to be
mounted on a 3-gang wall box, use the screws supplied with the wall box cover plate to attach the Wall
Mount. If mounting to the drywall with wall anchors, use four (4) quality wall anchors. The mounting holes
are slotted and are 90° opposing to provide easy leveling. Level the mount and tighten the mounting screws.
Step 3:
Connect the 25-pin end of the break out cable to the EZIM. Next, mount
the EZIM to the back of the wall mount on the left side, using the two
tapped screw holes (see Figure 6). Connect the 15-pin video cable,
power connector and 8-pin mini-DIN connectors (VISCA IN is labeled)
from the EZIM to the back of the camera.
Figure 3:
Daisy chain control configuration using two (2) WallVIEW PRO Z330 systems and a single RS-232
output control device. See Appendix 1 for wiring and pin-out information.
RS-232 Out
RS-232 Out RS-232 Input RS-232 Input
Figure 4:
Wall Mount with oval cable feed-through hole.
The wall mount may be mounted directly to a
3-gang wall box or to the dry wall with the
appropriate wall anchors.
Note: Z330 Wall Mount looks slightly different
Figure 5:
25-pin break out cable
connected to EZIM
(left); EZIM and break
out cable installed in
Wall Mount (right).